The Standard quartz bucket banger features a 25mm OD by 40mm height and a 4mm thick "gridded" bottom for optimized heat retention. You cannot go wrong with the Standard.
Specs:
Banger Type: 25 X 40mm full-weld quartz banger
Joint: 14mm male 90 degrees / 10mm male 90 degrees
Recommended Bead/Pillar type: beads (6mm but 4 & 8 are fine too).
Recommended Carb cap type: Spinner or Cyclone carb caps.
Maintenance & cleaning recommendations:
Avoid torching/heating over 650F/343C. Do not knock around and tap on solid surfaces. Always put down gently to avoid chipping/breaking, preferably onto softer surfaces once the banger has cooled to room temp. For in-between use clean, use dab cleaning specific long cotton buds. For deep-clean make sure items are at room temp, leave in 99% alcohol for 2 to 3 hours, remove, rinse with warm water and pat dry then leave outside to dry naturally (particularly) if the item has any kind of inlet holes in it.
